SE-TECH DISPENSERS

IDENTIFY  YOUR DISPENSER

All Se-Tech dispensers are primarily identified by the size of their inlets and outlets:

  • The 50mm units have 2” tri-clover (quick-release) couplings on their Stainless Steel endcaps

  • The 32mm units have 1-¼ ” BSP threaded holes in their endcaps – and will usually have 1-¼ ” BSP tri-clover (quick-release) couplings screwed into them

  • The 19mm unit (no longer in production) had ¾” BSP threaded holes in the top and the bottom of its endcaps

 

For all Se-Tech dispensers, pre-booked services can be carried out same-day, or in less than 3 hours while you wait.

CURRENT MODELS

SERIES 1-32

The Series 1-32 Se-Tech has blue mounting plates (where it is screwed to the wall), black or (on very early models, gray) endcaps with (as above) 1-¼ ” BSP threaded holes in the side of its endcaps. Dispensate suction throughput is changed by winding the knurled knob at the bottom of the unit up and down.

Parts and Servicing are available for this unit.

SERIES 2-32

The Series 2-32 Se-Tech has blue mounting plates (where it is screwed to the wall), with longer black endcaps than the Series 1 and with 1-¼ ” BSP threaded holes in the side of its endcaps.

Dispensate suction throughput is changed via the 5-position “gearshift” at the bottom of the unit.

Servicing for this unit is available at our manufacturing facility.

SERIES 2-50

The Series 2-50 Se-Tech has Stainless Steel (silver in colour) mounting plates (where it is screwed to the wall) and endcaps, with 2” tri-clover couplings on the side of its endcaps. Dispensate suction throughput is changed via the 5-position “gearshift” at the bottom of the unit.

Servicing for this unit is available at our manufacturing facility.

SUPERSEDED MODELS

The Se-Tech 19mm dispenser was sold from the late 1980’s until the early 2000’s. It is distinguished by blue mounting plates (where it is screwed to the wall), thinner endcaps than the 32mm units with water inlet and outlet in the bottom and top of the caps, rather than on the side as in all other Se-Tech dispensers.

 

The Series 1-50 Se-Tech was sold from the late 1990’s until the early 2000’s. It has Stainless Steel (silver in colour) mounting plates (where it is screwed to the wall) and endcaps, with 2” tri-clover couplings on the side of its endcaps (a very few early models had 2” BSP sockets rather than the tri-clover couplings).

Dispensate suction throughput is changed by winding the knurled knob at the bottom of the unit up and down.

 

All parts are stocked and Servicing remains available for both superseded dispenser models below.

Singh's Engineering Services.

Proudly New Zealand made since 1979

Website creation by Jolly Elephant Design

Ph: +64 (7) 8493 108

Fax: +64 (7) 8493 108

Email: Fill out our contact form

66-68 Mahana Rd, Te Rapa, Hamilton, New Zealand